Hama SIRIUM1000ABT Kurzanleitung Seite 7

Risk of electric shock
• Do not open the device or continue to operate it if
it becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to quali ed experts.
4. Before commissioning
Note
• You have the option of powering the product via mains
power or batteries. In order to use mains power, simply
connect the product to a power source. To use battery
power, the battery must be fully charged beforehand.
Note
• Use only original accessories (or accessories approved
by Hama) to avoid damage to the product.
• Only use the product at ambient temperatures between
-10°C and 50°C.
• Only store the product at ambient temperatures
between -20°C and 60°C.
5. Start-up and operation
Warning
• Only operate the product from a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• Disconnect the product from the power supply using the
On/Off switch – if this is not available, unplug the power
cord from the socket.
• If using a multi-socket power strip, make sure that the
total power consumption of all connected devices does
not exceed the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged
period, disconnect it from mains power.
5.1 Mains operation
Switching on
• Connect the mains lead on the loudspeaker to a properly
installed socket.
The loudspeaker switches on automatically.
Note – switching on for the first time
• When rst switched on, the loudspeaker is in "Device
setup" mode and the status LEDs (1–5) pulse.
• If setup mode is not active, brie y press the [SETUP]
button (3) on the back of the device to activate WPS
mode ( ashes rapidly). Alternatively, press and hold
the [SETUP] button (3) for around 7 seconds to open
an AccessPoint ( ashes slowly).
• At the next switch-on, all of the status LEDs (1–5) ash
orange until the connections made so far have been
restored. Depending on the internet signal strength,
this may take up to 20 seconds.
5.2 Battery operation
Warning – rechargeable battery
• Use only suitable chargers to charge the device's battery.
• Do not use defective chargers or USB ports and do not
attempt to repair them.
• Do not store, charge or use the device in extreme
temperatures.
• Charge regularly (at least quarterly) during periods
of prolonged storage.
• The product contains a rechargeable battery.
• Fully charge the product once before using it for the
rst time.
• Connect the mains lead on the loudspeaker to a properly
installed socket. The socket must be installed close to the
product and must be easily accessible.
• The loudspeaker switches on automatically.
• During the charging process, the current charge level
is indicated by the status LEDs.
3