E-Mu 1212M PCI Bedienungsanleitung Seite 5

Connecting the MicroDock to the E-MU 1010 Card
Connect the supplied network-type cable from the RJ-45 jack on the E-MU 1010 PCI card labeled "EDI" to the matching
connector labeled "EDI" on the MicroDock. The cable type is a standard CAT 5e network cable which is specially shielded to
prevent RF emissions. Contact E-MU Systems if you need a replacement cable.
CAUTION: Do not connect the supplied CAT 5e cable to the Ethernet or network connector on your computer. Doing
so may result in permanent damage to either your computer, the E-MU 1010 or both.
Supplying Power to the MicroDock
The MicroDock is powered from the supplied +48VDC Adapter. Connect the Adapter to the jack marked +48VDC on the
back panel of the MicroDock. Turn the MicroDock on by turning the Headphone Volume control up.
+48V DC Adapter
1010 PCI Card
48 VDC
+ -
EDI
The Headphone
Volume Control is
also the Power Switch.
Getting Started - 5