Installation; Operation - h.koenig MXK32 Bedienungsanleitung

1. Clean the measuring cup, cover and jar (except main body) and so on before first using.
2. To make sure the unit is turned off and not to connect before installation.
3. First ring the jar sealed ring into blade base, then enclose the blade base into jar, last rock
the jar slightly causing it to lock into place.
4. Fit the blender glass jar onto the main body, and turn it slightly in a clockwise so it locks
with the motor section. Fill the jug with the desired foods. Please ensure the water not
spill over from cup. ( Maximal water capacity cannot exceed 1500 ml)DO NOT USE THE
UNIT WITHOUT ANY MATERIAL INSIDE.
5. Put the cover on top of the jar and push it down. Insert the closure into the cover and turn
till it locks into place.
Place the measuring cup on the center of cover, anticlockwise rock the measuring cup
6.
slightly.
1. Connect the power.
2. This unit have safety design, it do not work if the jar is not install on main body properly.
3. Turn the turning knob P/0/1/2/3/4/5 to position 0 in order to make sure the unit is turned
off.
4. Fill the jug with the desired foods
5. Put the cover on top of the jar and fix it. Place the measuring cup on the center of cover,
anticlockwise rock the measuring cup slightly.
6. Put the blender glass jar onto the main body, and turn it slightly in a clockwise so it locks
with the motor base.and the machine was fully assembled.
7. Turning the knob to required speed (P—pulse, grade 1 to 5 means speed of blades from
low to high).
8. During working mode, the blue light around the knob is on.
Speed adjust :
P—pulse –Stainless steel blade operate with transitorily highest speed, suitable for ice.
1—Stainless steel blade operate with low speed.
2—Stainless steel blade operate with higher speed than grade 1 but lower speed than grade 3.
3—Stainless steel blade operate with higher speed than grade 2 but lower speed than grade 4.
4—Stainless steel blade operate with higher speed than grade 3 but lower speed than grade 5.
5—Stainless steel blade operate with higher speed than grade 4 and it is the highest speed of
the machine.
0—turn off the unit.
Caution :
1. Over-filled can block the operation, please turn off the unit and do not connect the plug, take out
some of material, then operating.
2. Do not use unit continuous more than 2 minutes.

INSTALLATION

OPERATION