Setting The Channel; Power Saving Mode - Hama M710 Bedienungsanleitung

• Smart-Link technology means that the standard functions of the mouse can
be used immediately.
• The software supplied must be installed to assign specific functions to the
3rd (wheel) button and the additional buttons at the side. (See section 2)

1.3 Setting the channel

• If other wireless mice cause interference during operation, switch to the
other channel and then reconnect the mouse to the receiver (section 1.4).
Fig.4
1.4 Connecting the mouse and receiver
• Press the connect button on the receiver. The status indicator starts to flash.
(Fig.5)
• Then press the connect button at the bottom of the mouse. (Fig.4)
Fig.5
Connect button
Channel selection switch
Connect button
Status indicator
8
1.5 Charging indicator lamp in the scroll wheel of the mouse (M710/M2010 only)
The scroll wheel lights read to indicate when the rechargeable batteries in the
mouse are low. When this occurs, connect the USB charging cable to the mouse.
It takes approx. 8 hours to charge. You can continue to use the mouse while it is
charging.
Fig.6
1.5 a)
Battery indicator lamp in the scroll wheel of the mouse (M610 only). The scroll
wheel lights read to indicate when the batteries in the mouse are low. When this
occurs, replace the batteries as soon as possible.
1.6 Switching the mouse on/off
Proceed as follows to switch the mouse off completely.
• Press the scroll wheel and hold it down. (Fig.6)
• Press the connect button. (Fig.4)
• The mouse is now switched off, i.e. it is not ready for operation.
• Follow the same procedure to switch on the mouse.

1.7 Power saving mode

If the mouse is not used for 10 minutes, it switches to power saving mode. The
sensor is switched off to minimise the power consumption. In this mode, no
actions can be performed using the mouse. Press any button to activate the
mouse.
2. Installing the software
• Uninstall any mouse software already installed.
• The software supports Windows 98/2000/ME and XP.
a) Place the enclosed CD in your CD-ROM or DVD-ROM drive. Wait a moment,
installation is started automatically.
6. Mouse button
Scroll wheel
USB charging cable
9