L Operating Instructions
L
1. Installing the hardware
1.1 Inserting batteries
•
Remove the battery cover at the rear of the mouse and insert the
batteries the right way around in the battery compartment (Fig. 1). The
poles are indicated there.
•
Close the battery compartment
1.2 Connecting the receiver
USB version
•
Connect the USB plug of the receiver to the PC
USB socket or a USB hub.
PS/2 version
•
If you have not already done so, shut down your
computer and switch it off*.
•
Connect the PS/2 connector of the receiver
(via the USB-PS/2 adapter) to the PS/2 mouse
connector (green) on the PC.
•
Switch on your computer and boot the system.
*Do not connect PS/2 version mouse when computer is switched on. This can
cause damage to your PC.
•
The software supplied must be installed to assign specific functions to the
3rd (wheel) button and the additional buttons at the side. (See section 2)
-
+
Fig.1
-
+
connect button
5
Fig.2
Fig.3