Interlogix TX-2344-03-1 series Installationsanleitung Seite 5

Detector modes and LED states
Table 1: Detector modes
Mode
Power supply
Low battery
Flat battery
Starting up
Not enrolled
No communication
Operation
Walk test mode
Range test mode
Good range
Medium range
Weak range
No communication
for 15 s
No communication
for 1 min
Enrolling and deregistering
Not enrolled
Already enrolled
Continuously on Normal blinking (1 Hz)
P/N 1078288 (ML) • REV C • ISS 31MAR15
Indication details Description
Depend on other Battery voltage < 2.8 V.
states PIR is functional, camera takes pictures only on command.
Battery voltage < 2.4 V.
Device locks up, no operation.
Red LED PIR starts up in legacy mode.
continuously ON Walk test is enabled from 1st to 5th minute after powering on.
during 1 minute Camera functionality is disabled.
Device is ready for enrollment.
Green and red LEDs PIR starts up in legacy mode.
alternate during Walk test is enabled from 1st to 5th minute after powering on.
1 minute Camera functionality is disabled.
Device is seeking for communication with the panel.
Camera is synchronizing with the expander.
Red LED is ON for PIR functionality is enabled.
3 s to indicate motion Continuous alarm detection without lockup.
detected Pictures on PIR alarm and on tamper alarm.
The mode is activated from the control panel.
The device is on hold, only LED indication is functional.
The LED follows the weakest communication link of LDR and HDR.
See an appropriate wireless expander manual for details on the
communication quality.
See an appropriate wireless expander manual for details on the
communication quality.
See an appropriate wireless expander manual for details on the
communication quality.
Blinking LED color reflects the last range measured just before
communication started to fail.
Permanent loss of communication turns range testing off.
Note:
Red LED turns ON Enrollment of a device is possible only if the system is in enrollment mode.
while enrolling for a Enrollment of a device is possible only if the device is not already enrolled.
maximum duration of Tamper switch toggling triggers the enrollment process.
15 seconds, changing Successful enrollment permanently associates a device with the system.
to green on success.
Enrollment of a device is not possible without deregistering the device first.
Deregistering is accomplished by applying the KILL jumper (see Figure 10,
item 1) and cycling power.
Successful deregistering dissociates a device from the system.
Fast (4 Hz)
The mode is activated from the control panel.
5 / 42