General Guidelines; Battery Replacement - Interlogix TX-2344-03-1 series Installationsanleitung

9
5X 6 m
10
(1)
EN: Installation Manual
Description
TX-2344-03-1 / TX-2344-03-1-N is a wireless PIR detector with
a camera built-in. It combines the patented PIR mirror optics
technology and wireless photo transmission.

General guidelines

See Figure 2.
The camera is intended to be mounted on walls, but can also
be mounted on ceilings by using a mounting bracket.
Use the following guidelines to determine the best location to
install the camera.
•
Mount the camera so the expected movement of an
intruder is across the detection pattern (see Figure 7).
•
Mount the camera at a stable surface at a height between
1.8 m and 3.0 m from the floor.
P/N 1078288 (ML) • REV C • ISS 31MAR15
1A 9A
5B
1B 9B
2B-3B 7B-8B
4 6
7X 6 m
9A
9B
8B
7B
6
5B
5X 12 m 7X 12 m
•
Do not mount the camera within 0.5 m of metallic objects
or within 1.5 m of fluorescent lights.
•
Do not place objects in front of the camera that may
prevent a clear line of sight.
•
Place cameras at least 1 m apart from each other.
The PIR technology processing of its detector is very resistant
to false alarm hazards. However, avoid potential causes of
instability, such as:
•
Direct sunlight on the detector
•
Heat sources within the detector field of view
•
Strong air draughts onto the detector
•
Animals in the field of view
•
Obscuring the detector field of view with large objects,
such as furniture
We recommend that the camera is regularly walk tested and
checked at the control panel.

Battery replacement

This product contains three lithium DL123A-type 3 V single-use
batteries. Because removing batteries may affect the product
configuration settings or trigger an alarm, only a qualified
installer should remove the batteries.
Cautions
•
All three batteries must be fitted.
•
Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the
instructions below.
•
Always replace all batteries in the compartment. Do not
use old batteries together with new ones.
To remove batteries:
1. Make sure that your alarm system settings allow you to
open a detector enclosure without starting the tamper
alarm.
1A
1B
2B
3B
4
9X 12 m
3 / 42