Safety Instructions - Velleman VTSSC50N Bedienungsanleitung

VTSSC50N – SOLDERING STATION WITH LED & CERAMIC HEATER
1. Introduction & Description
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VTSSC50N! Please read the manual carefully before bringing this device into service.
Thanks to its favourable price-quality ratio, this device is ideal for beginners and professionals alike.
2. Characteristics
1. Insulated ceramic heater
2. The device is equipped with an electronic, temperature-controlled analogue scale. The operating temperature can
vary from 200 to 420°C and is set manually.
3. The soldering station is equipped with a temperature control lock to prevent unwanted temperature adjustments
and a LED comes on when the device is activated.
4. Simply remove the barrel and the nut in order to replace the tip. Several types can be mounted.

3. Safety Instructions

• Incorrect use of this tool may cause fire.
• Be cautious when using this tool in places where inflammable products are stored.
• Heat can cause fire to inflammable products even when they are not in sight.
• Do not use the tool in an explosive atmosphere.
• Place the tool back in its stand in order to let it cool down before storage.
4. Operating Instructions
• Verify whether the operating voltage of the unit is compatible with the mains voltage prior to plugging in this
device.
• Make sure that the device was not damaged in transit.
• Use the rotary control on the front panel to set the desired temperature.
5. Common Causes for Tip Failure
1. The tip is not sufficiently tinned.
2. Wiping the tip on a surface with high sulphur content or on a dirty or dry sponge or rag.
3. Contact between the tip and organic or chemical substances such as plastic, silicone, grease, etc.
4. Impurities in the solder and/or solder with a low tin content.
Note: The heating element may be damaged when its temperature reaches 430°C (806°F).
VTSSC50N_v2
3
VELLEMAN