Safety Instructions; Important Remarks; User Manual - Velleman VTSSC50N Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions

Warning: this tool must be placed on its stand when not in use; do not leave the tool
unattended when switched on.
 Incorrect use of this tool may cause fire.
 Be cautious when using this tool in places where inflammable products are stored.
 Heat can cause fire to inflammable products even when they are not in sight.
 Do not use the tool in an explosive atmosphere.
 Place the tool back in its stand in order to let it cool down before storage.
 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
 This device can be used by children aged from 8 years and above, and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning the use of the device in a safe way and understand the hazards involved. Children
shall not play with the device. Cleaning and user maintenance shall not be made by children without
supervision.
3. Features
 manual temperature setting
 power-on LED indication
 with on/off switch
 ceramic heating element
 with stand for left- or right-handed use
 standard tip (incl.): BITC50N2 (1.0 mm).
4. Operation
 Verify whether the operating voltage of the unit is compatible with the mains voltage prior to plugging in
this device.
 Make sure that the device was not damaged in transit.
 Use the rotary control on the front panel to set the desired temperature.
5. Common Causes for Tip Failure
 The tip is not sufficiently tinned.
 Wiping the tip on a surface with high sulphur content or on a dirty or dry sponge or rag.
 Contact between the tip and organic or chemical substances such as plastic, silicone, grease, etc.
 Impurities in the solder and/or solder with a low tin content.
Note: The heating element may be damaged when its temperature reaches 430 °C (806 °F).
6.

Important Remarks

 Remove and clean the tip after heavy or moderate use. We recommend cleaning the tip every day if the
device is used on a daily basis. Clear excess solder from the tip assembly.
 The supplied soldering tip is made of iron-clad copper and will retain its projected life span if used properly.
V. 06 – 19/02/2016
Downloaded from www.Manualslib.com

USER MANUAL

manuals search engine
VTSSC50N
2 ©Velleman nv