Saw Bow Clamping Adjustment; Blade Tension Adjustment - Elite EHB-350DGSVIP Bedienungsanleitung

1. Switch On Main power (A, Fig 7-1).
2. Press button (E) to start the hydraulic pump.
3. Use switch (D) to select manual mode
4. Use switch (K) to raise the saw bow.
5. Move the material feeler (P, Fig 7-4) up to the top.
6. Switch off Main power (A).
7. Un-clamp saw bow, by rotating the lock lever
(S, Fig 8-1) to the left.
Figure 8-1: Mitre Cutting Adjustment
8. Pull-up the zero degree stop rod
(T, Fig. 8-2) as needed.
Figure 8-2: Zero Degree Mitre Stop
9. Rotate the saw bow to the desired angle by following the
scale (U, Fig 8-3).
10. Clamp saw bow again.

8.2 Saw Bow Clamping Adjustment

Note: - If the saw bow cannot be locked well, change the lever
position. Disengage the indexing, by pulling the lever (S, Fig 8-
4) down at the hub.
Figure 8-4: Adjust Mitre Clamping

8.3 Blade Tension Adjustment

Blade tension is important to the proper operation of the saw.
Blade tension is indicated on the Blade Tension Gauge (T, Fig
8-5). Turn the tension lever (U) clockwise until proper blade
tension is reached (green colour).
Figure 8-5: Blade tension gauge
17
Figure 8-3: Mitre Scale