Transport Installation Assembly Dismantling; Machine Transport; Installation Requirements; Unpacking And Clean-Up - Elite EHB-350DGSVIP Bedienungsanleitung

4.0 Transport Installation Assembly
Dismantling
WARNING:
Read and understand the entire contents of this manual
before attempting assembly or operation. Failure to comply
may cause serious injury.

4.1 Machine Transport

The machine needs to be moved in its own packing. Use a
forklift truck to place it.

4.2 Installation Requirements

- Main voltage and frequency must comply with the machine's
motor requirements.
- Ambient temperature should fall within –10°C to +50°C.
- Relative humidity may not be over 90%.

4.3 Unpacking and clean-up

Remove all contents from shipping crate and compare parts to
the contents list in this manual. If shipping damage or any part
shortages are identified, contact your distributor. Do not
discard crate or packing material until the machine is
assembled and running satisfactorily.
Clean all rust protected surfaces with kerosene or a light
solvent. Do not use lacquer thinner, paint thinner or gasoline,
as these can damage plastic components and painted surfaces.

4.4 Shipping contents

1 Metal band saw
1 Bar-stop rod
1 Roll-supporting arm
1 Owner's manual

4.5 Anchoring the machine

The machine is designed to operate in closed rooms.
Position the machine on a firm cement floor maintaining, at
the rear, a minimum distance of 800 mm from the wall.
Lift machine off the pallet to the desired location.
Use lifting straps and place them as shown in Fig. 2-1.
WARNING:
The machine weight is 677 kg
Assure the sufficient load capacity and proper condition of
your lifting devises. Never step underneath suspended loads.
Anchor machine to the ground, using screws and expansion
plugs or tie rods sunk in cement, ensuring that it is sitting level.
Figure 2-2: Anchor bolts

4.6 Assembly of Loose Parts

Install the components supplied:
1) Mount the bar-stop rod
2) Mount the roll-supporting arm and align as per the vise
bed.
4.7 Deactivation of the Machine
- If the sawing machine is to be out of use for a long period, it
is advisable to proceed as follows:
1) Detach the plug from the electric supply panel
2) Loosen blade tension
11
Figure 2-1: Machine lifting