Femi 360 MULTY Gebrauchsanleitungen Seite 17

Then proceed to extend all the support feet (3). Pull
each foot out until it reaches its full extension and the
locking device (4) has clicked into position.
Ã
AvtÃ$Ã
Ã86VUDPI)Ãà 8 urpxà v‡uà ‡urà ˆ‡€‚†‡Ã ph…rà ‡uh‡Ã
hyyà ‡urà †ˆƒƒ‚…‡Ã srr‡Ã uh‰rà irrÃ p‚€ƒyr‡ry’Ã
hqà p‚……rp‡y’à r‘‡rqrqà hqà h…rà sˆyy’Ã
†ƒyh’rqÇ‚Ãr†ˆ…rÇurÃirpuÃ…r€hv†Ã‡‚‡hyy’Ã
†‡hiyrÇu…‚ˆtu‚ˆ‡Ãˆ†rÃÃ
Ã
AvtÃ%Ã
Ã
• Slacken the locking knob (5) in order to extract the
bar (6) in which the support devices will be
positioned.
• Then tighten the knob (5).
• Slacken the locking knob (7) in order to insert the
support device (8) in the bar(6).
• Then tighten the knob (7).
Ã
Ã
• Insert the bolt on the work-piece support system
(10) in the circular slot (9) located on the support
device (8) so that the work-piece support system
(10) can slide along the guide on the device itself.
• Once the work-piece support system (10) has been
positioned correctly, block it in place by turning
knob (11).
Ã
AvtÃ&Ã
AvtÃ'Ã
AvtÃ(Ã
13