Altitude History Display; About Altitude Change Memory; Clearing Altitude Memory, Max / Min Altitude Memory, And Vertical Ascent / Decent Memory - Oregon Scientific EB833 Bedienungsanleitung

ALTITUDE HISTORY DISPLAY

In addition to having altitude information displayed as a
graph, altitude history can also be displayed numerically.
To numerically display previous altitude levels:
1. Enter the Altitude History Display
2. Press [+] or [-] to display the corresponding altitude
history for a specified time period up to –12 hours.

ABOUT ALTITUDE CHANGE MEMORY

The EB833 can monitors the change in altitude between
two points. The unit displays the net vertical difference
between points of a descent / ascent. Upon clearing the
altitude memory, the current altitude reading is used as
a base from which the unit starts recording changes.
Point A: At this point, reset the Altitude Change Memory
to 0 m./ ft. The EB833 will immediately start
recording new changes in altitude.
Point B: At this point, check the Altitude Change Memory.
The unit will display the net vertical difference
between point A and point B.
CLEARING ALTITUDE MEMORY, MAX / MIN
ALTITUDE MEMORY, AND VERTICAL
ASCENT / DECENT MEMORY
Altitude related memories are cleared sequentially. During
the sequence, correct information can be bypassed by
pressing [ALT].
NOTE To clear the maximum altitude reached memory,
first enter MAX Altitude Display. Alternately, enter MIN
Altitude Display to clear the minimum altitude reached
memory.
To clear Altitude Mode Memories:
1. Enter Altitude Max (or Altitude Min) Display.
2. Press and hold [ALT] for about 2 seconds, the
change-in-altitude digits flash.
NOTE To bypass any section without making changes
to the memory, press [ALT].
3. Press [+] or [-], the change-in-altitude digits will reset
to 0 m./ft.
4. Press [ALT], and proceed to the maximum (or
minimum) height reached memory. The subsequent
maximum (or minimum) altitude digits flash.
7