Operation - Blaupunkt SMART CHARGER 170 Bedienungsanleitung

OPERATION

Before use
Before connecting the charger, the operating instructions must be observed. Furthermore,
the instructions of the vehicle manufacturer regarding a permanently connected battery
charger must be observed. Secure the vehicle, switch off the ignition and locate the
battery compartment.
Clean the battery poles and terminal leads. Wear eye protection and ensure sufficient
ventilation is available while charging.
Connect the pole clamp lead set or cigarette lighter plug lead set to the output cable 17
using the SAE sockets 18 .
Connecting with Pole Clamp Set:
Connect the "+" pole clamp (red) 14 to the "+" pole of the battery.
Connect the "-" pole clamp (black) 15 to the "-" pole of the battery.
Connecting with Cigarette Lighter Plug Set:
Charge or maintain your battery without lifting the hood.
Insert the cigarette lighter plug 16 into the 12V accessory outlet. Route the power
cord from the charger through the vehicle's open window.
The battery voltage display 9 shows the current battery terminal voltage – display light 6
illuminates.
Make sure to place the charger on a dry, non-flammable surface like metal or concrete.
Then connect the mains cable 13 of the charger to a mains power socket and switch on.
Should the connection of the clamps or cigarette lighter plug be incorrectly connected
[reversed polarity], the "LED reverse connection" indicator will illuminate 5 .
Disconnecting with Pole Clamps:
Disconnect the appliance from the mains supply by switching the power off and removing
the mains cable 13 .
Remove the "-" pole clamp (black) 15 from the "-" pole of the battery.
Remove the "+" pole clamp (red) 14 from the "+" pole of the battery.
Disconnecting with Cigarette Lighter Plug Set:
Disconnect the appliance from the mains supply by switching the power off and removing
the mains cable 13 .
Disconnect the cigarette lighter plug lead set from the 17 output cable using the inline 18
SAE sockets.
If leaving the cigarette lighter plug lead set attached to the 12V accessory outlet for later
use, then securely store the attached cigarette lighter plug lead set. Ensure the SAE socket
will not make electrical contact with any metal or moving component/s.
4