Establishing A Radio Frequency (Rf) Link - Targus PAWM002E Bedienungsanleitung

WARNINGS: when replacing the batteries, you may use
non-rechargeable (alkaline) or rechargeable (NiMH)
batteries. Never use non-rechargeable and recharge-
able batteries together in the mouse at the same time.
Avoid mixing new and used batteries in a device.
4 Slide the battery cover back into position until it "clicks"
firmly into place.
5 Turn on the mouse by sliding the on/off switch on the
bottom of the mouse to the "on" position.
The optical sensor, located on the bottom of the mouse,
illuminates.

Establishing a Radio Frequency (RF) Link

The mouse has 2048 identification codes that allow the
mouse and its receiver to operate without interference from
other RF devices.
After your computer detects the USB receiver and the
driver is installed, you must establish a RF link between the
mouse and its receiver BEFORE you can use the mouse. To
establish this link:
Make sure that your computer is turned on and has
detected the USB receiver before you establish a link.
1 Press and release the connect button on the receiver.
Status Light
The receiver's status light illuminates when the receiver
is activated.
Targus optical wireless notebook mouse
Receiver
9
Connect button