Parking Brake - EasyWalker DUO Gebrauchsanweisung

TIP: The carrycot has four black feet on the underside so that it can be used as a cot
without a supporting frame.
TIP: The hand grip in the sun canopy is suitable for lifting the carrycot if it has been lifted
up completely. In the bag, at the foot-end, there is an extra hand grip so that you can
safely carry the carrycot.
Using the EasyWalker DUO
IMPORTANT: Avoid dangerous situations. Always use the wrist band attached to the push-
bar. Take your child out of the EasyWalker DUO if you go up or down stairs, escalators or
steep hills.
IMPORTANT: Do not use the EasyWalker DUO if any part is broken, torn, incomplete or
does not seem to be functioning correctly.
IMPORTANT: The EasyWalker DUO is not designed for use when jogging or roller skating.
IMPORTANT: The rods between the rear wheels are not suitable for standing on. This is
unsafe and can damage the EasyWalker DUO.

Parking brake

IMPORTANT: Ensure that the parking brake is engaged when you place your children in or
remove them from the EasyWalker DUO.
Push the parking brake at the back of the frame gently downwards with the foot. Ensure
that the sides of the brake fall into the designated recesses on the rear wheels so that
the EasyWalker DUO cannot move (image 26). To release the brake on the EasyWalker
DUO, push the brake upwards with the foot (image 4).
Collapsing and opening out
! WARNING: Ensure that all the locking devices are engaged before use.
You can leave the seat and the sun canopy in place on the EasyWalker DUO when
collapsing and folding out. If using the EasyWalker DUO carrycot or a car seat these must
first be removed.
Position the front wheels with the wheels swivelled and pull the EasyWalker DUO
backwards slightly so that the front wheels turn forwards. Engage the parking brake and
turn the sun canopy upwards. Click the red safety catch (located on the right hand side
of the frame) upwards. Standing behind the pushchair, squeeze the unlocking handles on
both sides of the push-bar. Move the push-bar downwards while keeping the unlocking
handles pushed in (image 32+33). You can now close the locking hook on the rear axle
around the frame (image 1).
To open out the EasyWalker DUO, release the locking hook on the rear axle and pull the
EasyWalker DUO up by the push-bar. The EasyWalker DUO will unfold by itself. If you
hear a double click then the EasyWalker DUO has unfolded correctly. Check whether the
red safety catch on the right hand side of the EasyWalker DUO is in the locked position.
TIP: The four wheels and bumper bar can be removed to make the folded pushchair more
compact.
Raising the height of the push-bar
Release the left and right black clips on the inside of the push bar (located just under the
foam). Move the push-bar to the desired height and lock the clips (image 34).
EN-22