NETGEAR WNDAP620 Installationsanleitung Seite 4

e. If you use DHCP, reserve an IP address (based on the access point's
MAC address) on the DHCP server. You can then use that address to log
in to the access point.
f. Select Configuration > Wireless > Basic > Wireless Settings and
select the Turn Radio On setting.
g. Select Configuration > Security > Profile Settings and configure
security profiles for your network.
See the online help or the Reference Manual for full instructions.
3. Test wireless connectivity.
Using a PC with a wireless adapter, verify that you can establish a wireless
connection to the access point.
Now that you have finished the setup, you are ready to deploy the access
point in your network. If needed, you can reconfigure the PC you used in step
1 back to its original TCP/IP settings.
Deploy the Access Point
1. Disconnect the access point and position it where you will deploy it. The best
location is elevated such as wall or ceiling mounted, at the center of your
wireless coverage area, and within line of sight of all mobile devices. Make
sure the dome side of the AP points toward users.
Ceiling Mount
Note: DO NOT place the AP in a false ceiling space facing up.
2. Connect an Ethernet cable from your access point to a LAN port on your
router, switch, or hub.
3. Connect the power adapter to the wireless access point and plug the power
adapter into a power outlet. The Power and LAN LEDs should go on.
English
Wall Mount
3