Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Problems
The machine does not switch on.
Pilot light
OFF after pressing the main
switch .
The machine requires a lot of time to
heat up.
The pump is very noisy.
The loading lever doesn't reach the
brewing position.
The coffee is brewed too fast, the brewed
coffee is not creamy.
Coffee not supplied and steam coming
out of the capsule compartment.
Coffee is not brewed or brewed in drips
only.
• Nominal Voltage - Power Rating - Power Supply:
See the plate placed on the machine
• Dimensions: Height
12" (305 mm)
• Weight: about 11 lbs. (5 kg)
• Water tank: 30,5 oz. (0.9 litres) - Removable type
TROUBLESHOOTING
Causes
» T he machine is not connected to the
power source.
» M achine affected by limescale deposits. » Descale the machine.
» There is no water in the tank.
» Spent capsule drawer filled.
» Capsule fitted incorrectly.
» Spent capsule.
» T he loading lever was not set to the
brewing position.
» Dispensing spout is clogged.
TECHNICAL SPECIFICATIONS
Width
Depth
9.25" (235 mm) 13" (330 mm)
Client Service Lavazza A Modo Mio
0800 599 9200
Fax. +44 (0)1895 209 778 e-mail: info@lavazzamodomio.co.uk
Solutions
» Connect the machine to the power source.
» Contact customer service.
» Fill-up with fresh drinking water.
» Empty the spent capsule drawer.
» R epeat the sequence, lever in the off position, lever
in the brewing position; if this is not enough, operate
manually to remove the capsule from the duct with
the machine disconnected from power mains.
» B ring the lever back to rest position and load a new
capsule.
» Set the loading lever to the brewing position.
» Clean the dispensing spout.
• Housing Material: ABS - Thermoplastic
• Power Cord Length: 47" (1.2 m)
• Control Panel: Top of machine
• Thermal fuse
• Aluminium flash boiler with temperature probe
Werbung
Inhaltsverzeichnis
