Starting The Machine; Stand-By Function - Simpla Lavazza A MODO MIO Bedienungsanleitung

No liability is held for damage caused by:
• incorrect use not in accordance with the intended
purposes;
• repairs not carried out by authorized service centres;
• tampering with the power cord;
• tampering with any parts of the machine;
• use of non-original spare parts and accessories;
• failure to descale;
• storage at temperatures below 4°C (39,2°F);
• use at temperatures below 10°C or above 40°C;
• use at a relative humidity above 95%;
• using non-compatible capsules.
In these cases, the warranty is not valid.

STARTING THE MACHINE

Place the machine on a flat and stable surface, away from water and
heat sources. Disconnect the power if connected. Lift the machine
only by using the appropriate lifting handle provided on the upper
part. (See MACHINE COMPONENTS
machine resulting from the failure to follow these instructions will
not be covered by the warranty.
High electromagnetic interferences could affect the regular opera-
tion of the machine. If need be, power the machine OFF via the main
switch, then power it ON again to restore operation. If the problem
persists use the machine in a place not affected by electromagnetic
interferences.
Lift and remove the cover,
1
then take the water tank
out.
Rinse the tank.
2
Fill the water tank up to the
3
MAX level indicated, using
only fresh, non-sparkling,
drinking water
Hot water and other liquids may damage the tank and the coffee
machine. Never start the machine with no water in the tank: make
sure the water level is over the MIN level marked.
MACHINE SETTING
4
5
6
- Picture A). Damages to the
7
Using a water filter extends the life of your machine, protects
it from limescale and enhances the quality of water. We rec-
ommend BRITA FILTER "AquaAroma Crema" (optional attach-
ment). Follow the instruction sheet attached to the filter to
install it.
Connect the power cord, press the main switch to position I.
The stand-by button comes ON.
Press the stand-by button to power the machine ON.
The machine starts the heating cycle. The coffee supply button
starts blinking whereas the stand-by button comes OFF.
The machine is ready for use when the coffee supply button is ON
with steady light and a double sound is heard.

STAND-BY FUNCTION

In order to guarantee energy saving, after 10 minutes of non-use the
machine will automatically enter the stand-by mode which is point-
ed out by the lighting up of the button. The machine can be set in
stand-by mode manually by pressing the relevant button.
Press the button again to restart the machine.
E N