Measured Value Memory; Saving Readings; Retrieving Measured Values From The Buffer; Retrieving Measured Values From The Memory - Kaleas LDM 500-60 Bedienungsanleitung

LDM 500-60 ENGLISH

Measured value memory

All measured and computed values can be saved. The values are
stored together with their unit of measurement (length, surface ar-
ea or volume). Calculated values are stored together with the re-
spective individual values.
A total of 32 memory addresses are available. The memory is occu-
pied according to the "first in, first out" principle. When a value is
stored, it is saved to memory address 1. All other values are shifted
up by one memory address, and the value stored in memory ad-
dress 20 is deleted.
 The contents of the memory cannot be explicitly cleared.

Saving readings

1x
>2 s

Retrieving measured values from the buffer

The buffer allows quick access to a single memory value. The buffer
is ideally suited if you plan to use a value multiple times.
1x
short
1x
short

Example
: You want to determine the volumes of several rooms with
the same ceiling height. Measure the room height once and store
the value to the buffer by pressing the [T2] button longer than 2
seconds. Then insert the value as the height when using the volume
function by pressing buttons [T2] and [T1] successively to retrieve
the value and apply it.

Retrieving measured values from the memory

2x
© KALEAS GmbH & Co. KG
 Display [10]
The value from the display [4] is saved to the buffer
and memory address 1
 Display [10]
 Display [4]
The value is available for use in all functions.
 Display [10]
Value from buffer
33