Initial Use; Inserting / Replacing Batteries; Hand Strap - Kaleas LDM 500-60 Bedienungsanleitung

LDM 500-60 ENGLISH
Moreover, use of the Pythagorean functions allows distances to be
determined that cannot be established with conventional measuring
equipment, or are extremely complex to establish.
The ability to save as many as 32 measured values simplifies logging
the readings and their further use for arithmetic operations.
The backlit display [D] is easy to read even under unfavorable light-
ing conditions.
The LDM 500-60 is a robust meter and equally suited for daily use
on construction sites and by ambitious do-it-yourself enthusiasts.

Initial use

Before operating the meter for the first time, check the Distance
Meter and accessories for completeness (see "Product contents",
page 40).

Inserting / replacing batteries

 To insert the batteries, flip the angle stop [G] open 180º.
 Open the battery compartment [F] by pushing up the latch of the
battery cover and pivoting it upward.
 Insert the supplied batteries or two identical AAA batteries.
!
To avoid damage, observe the correct polarity of the battery.
 Close the battery cover by inserting the two top tabs
at a flat angle into the housing. Then, pivot the
cover downward and engage the latch until the
cover is snug.
 Flip the angle stop [G] back against the meter.
!
Always replace the two batteries at the same time.
!
If you use rechargeable batteries, ensure that both are charged
equally.
!
Remove the (rechargeable) batteries if the meter is not being used for
an extended period to prevent damage from leaking batteries.
 The battery status [9] symbol indicates the charge of the batteries.
Replace the batteries when the symbol is flashing continuously.

Hand strap

Attach the carrying strap to the housing by pulling the cord through
the opening [I]. If necessary, you may use a thin, dull object, such as
© KALEAS GmbH & Co. KG
25