Installation - Siko MA04 Montageanleitung Und Benutzerinformationen

User Information
MA04
Electronic Display
ENGLISH
1. Warranty information
In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and
the operating reliability of the device.
• Your device has been quality controlled, te-
sted and is ready for use. Please respect all
warnings and information which are marked
either directly on the device or in this document.
• Warranty can only be claimed for components
supplied by SIKO GmbH. If the system is used
together with other products, there is no warranty
for the complete system.
• Repairs should be carried out only at our
works. If any information is missing or unclear,
please contact the SIKO sales staff.
2. Identification
Please check particular type of unit and type
number from the identification plate. Type num-
ber and the corresponding version are indicated
in the delivery documentation.
e.g. MA04-0023
MA04 Datum 08.01.2002
version number
type of unit
Art.Nr. 77726

3. Installation

The unit should be used only according to the
protection level provided. Protect the unit, if
necessary, against environmental influences
such as sprayed water, dust, knocks, extreme
temperatures.
Built-in housing EG60
• Push the device into the panel (1) until the
panel clips (2) hold the housing loosely.
Press the lateral centering (3) slightly down and
push the housing into the cut-out (1) until the
panel clips (2) snap completely.
3
Fig. 1: Installation EG60
2
1
Fig. 2: Mounting EG30
EG30: Push device into panel (1). Tighten brak-
ket screw on the rear (3). Align device on front
plate and tighten screw (2).
4. Electrical connection
• Only fix / remove connectors with power off!
• Wiring must only be carried out with power off!
• Provide standed wires with ferrules.
• Check all lines and connections before swit-
ching on the equipment.
Interference and distortion
All connections are protected against the effects
of interference. The location should be selec-
ted to ensure that no capacitive or inductive
Z.Nr. 8664061
1
2
3
Änd.Stand 389/01 7