Incubation Mode ('Run'); Create Or Edit Pcr Programs ('Programs') - Peqlab peqSTAR series Kurzanleitung

Short Manual peqSTAR thermal cyclers
5.3

Incubation mode ('Run')

Use the button in the 'Run' dialogue to set the device into the incubation mode. The temperature for the
thermal plate and lid can be set manually. The clock shows the time passed by in the incubation mode.
5.4

Create or edit PCR programs ('Programs')

1. To create or edit PCR programs go to the 'Programs' dialogue.
2. By touching the 'Programs' dialogue the first time during the session the selection dialogue shows up
where a new program can be set over 'New' or an existing program can be opened over 'Open' to edit.
3. On the left side of the program editor all available commands are displayed, on the right side of the
editor the list of commands (Steps) the program is composed of is shown. After selecting a program
command out of the list in the left window it can be inserted into the desired place via the
4. Via double click or the 'Edit' button
5. Selected program steps can be deleted from the program by using the 'Delete' button
6. Use the 'Save' button
7. Save and start programs in one step by simply using the 'Save&Run' button
8. For even faster programming the peqSTAR thermocycler comes with a selection of template programs,
which could easily be edited and saved under a new program name.
PEQLAB_v1212E
parameters of single steps can be changed later.
to save the program.
Adding and removing
program steps
5
List of available commands
Program name
button.
.
.
Program window