Important Remark; Conformity With International Standards; Introduction; Auto Power Off - Ecler AMPACK25 Bedienungsanleitung

1. IMPORTANT REMARK

Congratulations! You are the owner of a carefully designed and manufactured equipment.
We thank you for having purchased our compact amplifier AMPACK.
It is VERY IMPORTANT that you read this manual before connecting the amplifier in order
to obtain its maximum performance.
We recommend our authorised Technical Services whenever any maintenance task should
be needed so that optimum operation shall be achieved.

1.1. Conformity with international standards

The AMPACK amplifier series complies with the following international standards:

EN55103-1 Electromagnetic compatibility.

Product family standard for audio, video, audio-visual and entertainment lightning control apparatus
for professional use

Part 1: Emission

EN55103-2 Electromagnetic compatibility.

Product family standard for audio, video, audio-visual and entertainment lightning control apparatus
for professional use

Part 2: Immunity

EN60065 Audio, video and similar electronic apparatus. Safety requirements
Guidelines 73/23/EEC and 2004/108/EC are therefore accomplished

2. INTRODUCTION

The compact amplifiers AMPACK series offers the most resistant and reliable amplification
technology available. Its design allows its usage in nearly every place and application that requires
power values up to 80W RMS at low impedance.
The AMPACK series offers the following features:

78W RMS (AMPACK80) / 24W RMS (AMPACK25) stereo amplifier

220-240V 50/60Hz power supply

AUTO POWER OFF: when no signal is present on the input, the AMPACK unit enters the standby
mode, reducing its power consume

Stereo, parallel and bridge operation possible

VCA based remote control for attenuation. Independent for each input channel

EUROBLOCK connectors for VCA input, output and control

Additional stereo RCA input connector

Independent gain controller for each channel

100Hz high pass filter

Controllers protected against accidental manipulation

Can be directly installed on 35mm DIN rail or individual holder
4