Intercom Operation; Extended Functions Of The Z-Link In Combination With A Mobile Phone, Navigation System Or Intercom; Mp3 Mode - Louis Probiker KX4 Z-Link Bedienungsanleitung

Intercom operation

7. Intercom operation
Once two Z-Link devices have been paired, rider-to-pillion communication
can take place.
1. Switch on both Z-Link Bluetooth systems by pressing the phone button on
both operating units for approx. five seconds. You will hear a sound signal
and the blue LED lights up.
2. Then press the "+" and "-" buttons at the same time on both Z-Link operating
units for approx. five seconds until the red and blue LEDs light up alternately.
The devices are now in pairing mode.
3. Now press and release the phone button on one of the two Z-Link devices
(this automatically becomes the master). You will hear a sound signal,
which is repeated 2-3 times. The two Z-Link systems now connect with one
another automatically.
Note:
Once pairing is complete, the Z-Link LED lights up blue. If connecting takes
longer than two minutes and the blue and red LEDs continue to light up, it
means a connection could not be established and you will have to repeat steps
1-3. Once you have paired the devices successfully, you do not have to repeat
this process. The two Z-Link devices will now detect each other automatically
after switch on.
Operating in intercom mode
1. Ending the intercom function
Press and release the phone button; you will hear a sound signal from the
two Z-Link devices coupled to one another.
2. Starting the intercom function
Press the phone button for approx. two seconds; you will hear a sound
signal from the master Z-Link and two sound signals from the slave Z-Link
device. The intercom starts automatically.
Note:
Master/slave – are general names for Bluetooth systems. The master controls
the communication whereas the slave is just a participant.
34
8. Extended functions of the Z-Link in combination with a mobile phone,
navigation system or intercom

8.1. MP3 mode

You can receive a phone call or an intercom call whilst listening to music.
You cannot play music during a phone conversation. When you have finished
talking, the music automatically continues from where it was stopped.
1. Receiving a phone call
The music stops automatically and you hear a sound signal alerting you to an in-
coming call. Press and release the phone button to take the call. When you want
to end the call, press and release the phone button again and the music conti-
nues playing.
Note:
A sound signal will inform you if a call comes in while you are talking on the
phone. Press and release the phone button to end the current call. Then press
the phone button again to receive the incoming call and start talking.
2. Last number redial
Press and release the phone button twice. The music stops playing automatically,
you hear a sound signal and the number is dialed. Press and release the phone
button to end the phone conversation or wait until your partner hangs up.
The music continues automatically once your phone conversation has ended.
3. Starting intercom communication
Press the phone button for approx. two seconds, the music stops automatically,
you will hear a sound signal and intercom communication starts immediately.
When you want to end your conversation, press and release the phone button or
wait until your partner ends the connection. The music then continues automatically.
4. Receiving an intercom call
The music stops automatically, you hear a sound signal and the intercom
connection starts automatically. When you want to end your conversation, press
and release the phone button or wait until your partner ends the connection.
Extended functions
35