Important Information; Mounting Instructions - Duravit DuraSquare 700426 Montageanleitung

Important information

Mounting instructions information
These mounting instructions come as part of the Duravit
bathtub and should be read carefully prior to installation.
Explanation of the key words and symbols
Is used to address practices not related
NOTICE
to physical injury.
Link to the mounting instructions in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and leak-tightness
Target readership and qualifications
The bathtub must only be installed by trained plumbing
engineers.
Risk of product and/or property
NOTICE
damage!
> Observe the local installation regulations and any
country-specific standards at all times.

Mounting instructions

Please read pre-installation information sheets prior to
the installation. These are available to download on the
Internet at www.pro.duravit.com.
Mounting instructions
3
Mounting the cable-driven waste and overflow
The connecting hose #790166 is recommended for
mounting a cable-driven waste and overflow with a
bath spout or base inlet.
Providing for an inspection hatch
18
Area: Cable-driven waste and overflow
Dimensions of the inspection hatch
for the cable-driven waste: min. 20 x 20 cm
21
Using silicone without acetic acid
> Use alkoxy-based silicone.
Closing the inspection hatch
23
sealed to avoid spray water
only to be opened with a tool
5
BA_M_DuraSquare_built-in/17.02.1