Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Update from grandMA2 console or onPC (do not use in live situation)
The 2Port Node can be updated from a grandMA console or using the onPC software (only for onPC versions).
To do so, the 2Port Node must be present in the same network as the console (grandMA2, grandMA2 light,
grandMA2 ultralight, or grandMA2 onPC), i.e. the first 3 IP address groups must be identical. This very console
must run the desired software version (3.0 or higher).
If the cell „version" has a red background, the 2Port Node runs a software version different from that of the
console or onPC. In this case, you have to adapt the software versions as follows:
Create an USB-stick (FAT 32) with installation program
Open menu SETUP / NETWORK / MA NETWORK CONFIGURATION / DMX Nodes at the console or onPC.
Connect USB-stick with the console.
Select the appropriate MA 2Port Node in the overview.
Press the button SOFTWARE UPDATE. After the automatic reboot of the MA 2Port Node, the cell "Version"
must be grayed.
NOTE: if the warning "waiting for update" appears in the display, the version update is unimplemented.
Repeat the update procedure (see above
Software / Firmware Update
Hold „Reset" -button.
Plug in power cord and network cable to a running onPC in the MA Node. After about 10 seconds "update
client" is displayed.
Release the „Reset" –button. „Update-Client waiting ..." appears in the display.
Open 2Port / DMX Nodes onPC menu and press „Update Nodes" / "2Port SW Update" button. After that
„updating... Packets X/Y" is displayed and transfer starts.
After successful update, the default display is visible again. The IP address, operating mode and XLR settings
remain after updating.
4port_v1.x.y.update
).
MA 2Port Node
Data
Transport
Safety
instructions
Safety and
environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
37
Werbung
Inhaltsverzeichnis
