Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- 16 -
/SN=x,..,x
This parameter specifies the devices to be operated in Synchronous
Data Transfer mode if this mode is supported by these devices,
independent of the Windows settings. Entering "/SN=1,4", for example,
enables the synchronous mode for SCSI-IDs 1 and 4. Hostadapters
supplied with a SCSI setup ignore this parameter and use the setup
settings instead.
/!DISC=x,..,x Specifies the devices for which the "disconnect" settings of
Windows device manager are to be ignored and with it this function is
not available.
7.
Installation under Windows NT
7 .1 General Information
Windows NT has a built-in standardised SCSI interface that allows you to adapt
your specific hardware to the different SCSI hostadapters. Hardware adaptation is
done by driver „DC2974.SYS" located in the „\WINNT95" directory on your installation
diskette. The device drivers required for running CD-ROM or removable disk drives
etc. are part of the Windows NT operating system providing an automatic setup
procedure which much facilitates the installation process. Windows NT differentiates
between two installation methods:
-
SCSI hostadapter installation during installation of Windows NT. This method is
deployed when the boot disk or the CD-ROM drive containing the Windows NT
installation CD is connected to your SCSI hostadapter.
-
Separate installation of your SCSI hostadapter on a fully configured Windows NT
system. You can choose this installation method also when first installing
Windows NT if the devices connected to your SCSI hostadapter are not required
for installation.
7.2 Installation During Windows NT Installation
First install Windows NT as described in the manual and keep your SCSI driver
diskette ready. Should you not work with the original diskette make sure that the disk
you are using contains the file TXTSETUP.OEM in the root directory and all other
Windows NT file in the „\WINNT" subdirectory. In the course of Windows NT
installation the installer gives you the option to set up additional SCSI hostadapters.
Insert your SCSI driver diskette into drive A: when prompted for it. The setup program
displays the exact name and type of your SCSI hostadapter and asks you to press
ENTER to confirm the information. Afterwards it installs your SCSI hostadapter.
7.3 Separate Installation
Run the SCSI Adapter utility from Windows' Control Panel and activate the
Drivers tab. On this tab first click on Add and then on Diskette. You will then be
Quick Guide
the
Werbung
Inhaltsverzeichnis
