Operating Elements And Connections; Remote Control; Safety Notes - Monacor TVSET-400PIR Bedienungsanleitung

Please unfold page 3. Then you can always see the
GB
operating elements and connections described.
Contents
1

Operating Elements and Connections . . . . . 8

1.1 Switch-over unit . . . . . . . . . . . . . . . . . . . . . . . . . 8
1.2 Remote control . . . . . . . . . . . . . . . . . . . . . . . . . 8
1.3 Camera with motion detector . . . . . . . . . . . . . . 8
2

Safety Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

3 Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
4 Mounting and Setting-up . . . . . . . . . . . . . . . . 9
5 Connection of the Units . . . . . . . . . . . . . . . . . 9
5.1 Monitor or video recorder . . . . . . . . . . . . . . . . . 9
5.2 Connection of the cameras . . . . . . . . . . . . . . . 9
5.3 Alarm output . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
5.4 Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
5.5 Power supply of the infrared remote control . . . 9
6 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
6.1 Manual camera selection . . . . . . . . . . . . . . . . 10
6.2 Operating mode AUTO . . . . . . . . . . . . . . . . . . 10
6.3 Operating mode SCAN . . . . . . . . . . . . . . . . . . 10
6.4 Adjustment of the dwell time . . . . . . . . . . . . . . 10
6.5 Switching on and off the acoustic alarm signal 10
7 Specifications . . . . . . . . . . . . . . . . . . . . . . . . 11
1 Operating Elements and Connections
1.1 Switch-over unit (figs. 1 and 2)
1 Display for the channel number and to confirm the
input
2 Light diodes which show the channel in which the
motion detector has been triggered
3 On/off switch for the internal signal device which
sounds when a motion detector is triggered
4 Alarm output jack (3.5 mm jack), in case of re-
cognized movement a 10 V control voltage is pre-
sent to activate a video recorder or an external
alarm device (max. 100 mA current rating)
5 Audio/video output jack OUTPUT to connect a
monitor or video recorder;
an adapter cable with phono plugs is supplied
together with the set
6 Audio/video input jacks CH1 - CH4
to connect max. 4 cameras of type TVCCD-530PIR
7 Jack DC IN 12V to connect the supplied power
supply unit
8 POWER switch
8
1.2 Remote control (fig. 3)
9 Numerical keys to enter the picture sequence or
dwell time
10 SCAN button for automatic sequential switching of
the cameras in a defined order
11 AUTO button for automatic sequential switching of
pictures of the cameras of which the motion de-
tectors have been activated
12 DWELL button to adjust the dwell time in case of
automatic sequential switching of pictures
13 PRGM button to start the programming procedure
of picture sequence or dwell time and for final con-
firmation
14 Buttons CH1 - CH4 for manual selection of an
input channel
The buttons not mentioned are without function for this
system.
1.3 Camera with motion detector (fig. 4)
15 Bracket for wall or ceiling mounting
16 Infrared light diodes to illuminate the object to be
monitored
17 Lens with fixed focal length
18 PIR motion detector (passive infrared)
2 Safety Notes
The units (switch-over unit, camera, and power supply
unit) correspond to the directive 89/336/EEC for elec-
tromagnetic compatibility. In addition, the power sup-
ply unit corresponds to the low voltage directive
73/23/EEC.
The power supply unit uses dangerous mains volt-
age (230 V~). To prevent a shock hazard, do not
open this unit! Leave servicing to authorized, skilled
personnel only. Besides, any guarantee claim ex-
pires if switch-over unit, power supply unit, or
camera has been opened.
It is essential to observe the following items:
Protect the units against heat and excessive cold
(admissible ambient temperature range 0 - 40 °C).
The switch-over unit and the power supply unit are
only suitable for indoor use. Protect them against
humidity.
The heat being generated in the switch-over unit has
to be carried off via air circulation. Therefore, the cir-
culation vents at the housing must not be covered
with any objects. Do not insert or drop anything into
the circulation vents! The unit may be damaged.
The camera housing is splashproof but not ab-
solutely watertight. Therefore, do not immerse the
camera in water.
Do not set the switch-over unit into operation, and
immediately disconnect the power supply unit from
the mains if:
1. damage at the switch-over unit, the camera, or
the power supply unit can be seen,
2. a defect might have occurred after a drop or simi-
lar accident,