Installation With Surface-Mounted Housing 6885-Xxx-500 (Ag/A 1.X); Dismantling - ABB Busch-Wächter GJ B000 6132 A0156 Betriebsanleitung

Installation/Fig. 7
4.4 Installation with Surface-mounted Housing 6885-xxx-500 (AG/A 1.x) (Fig. 7)
• Depending on where the line is to be routed, knock out one of the
wire entries in the side of the housing (Pos. 1) or on the base of the
housing (Pos. 2).
• Fit an entry gland, if necessary.
• Insert the necessary line in the surface-mounted housing.
• Attach the surface-mounted housing by means of screws.
• Connect the FM Insert in accordance with the connection diagrams (Fig. 1 to 2) and
attach it to the pins provided in the surface-mounted housing (Pos. 3).
4.5 To Dismantle the Presence Detector
• Via the outer housing ring, detach the Presence Detector from the FM Insert by pulling
it downwards.
GB
1
2
3
60