Electronic Module Assembly; Set Button; Res Button - Waeco Magicspeed Accessory Montage- Und Bedienungsanleitung

MS-ir2 24/06/03
(see H
SET button (see
After switching on the cruise control via the ON/OFF button (status LED in the ON/OFF
switch illuminates green), the current speed can be taken over by pressing the SET
button (status LED illuminates orange).
Accelerating
With activated plant (status LED orange) the vehicle speed can be increased by keeping
the SET button pressed. The speed increases by approx. 2.5 km/h per second. After re-
leasing the SET button the achieved speed is maintained.
Accelerating by tipping
A brief pressure on the SET button increases the speed by approx. 1 km/h per keystroke.
SET button (see
After switching on the cruise control via the ON/OFF button (status LED in the ON/OFF
switch illuminates green) the last driven speed can be set. The current speed is maintai-
ned if the speed is not any longer saved.
Decelerating
With activated plant (status LED orange) the vehicle speed can be increased by keeping
the RES button pressed. The speed reduces by approx. 2.5 km/h per second. After
releasing the RES button the achieved speed is maintained.
Decelerating by tipping
A brief pressure on the RES button increases the speed by approx. 1 km/h per keystroke.
15:27 Page 24

Electronic module assembly

SET button

E).

RES button

J).
24 24