Replacement Of Flashtube - Hensel EXPERT PRO 250 Bedienungsanleitung

Manual EXPERT / INTEGRA PRO Compact
Wait till modeling lamp has cooled down, and then carefully
remove the glass dome from the unit by pulling it out of the
spring mechanism (see page 30) and moving it straight away
without touching modeling lamp or flashtube (danger!).
Handle halogen lamp with care because of the high pressure
inside. Pull out halogen lamp and replace the modeling lamp
with a new one.
Avoid touching the halogen lamp with your fingers; this causes
a higher risk of explosion of the halogen lamp.

Replacement of flashtube

All unit types of EXPERT / INTEGRA PRO are fitted with a user
replaceable flashtube.
For replacement of flashtube switch off the unit, separate it
from the mains outlet and wait for at least 15 minutes.
Then carefully remove glass dome from head by pulling it out of
the spring mechanism (see page 30) and moving it straight
away from the head without touching modeling lamp or
flashtube (danger!).
Handle flashtube with care because of the high pressure inside.
Caution: In case of a damaged flashtube glass the electrodes of
the tube must not be touched in any case! In this case it is a
must to use isolated pliers for pulling out the flashtube!
First unwind the ignition cable from the connection pin of the
ignition. Then pull out flashtube and replace it with a new one.
Finally connect the ignition cable.
You must make sure that the appropriate flashtube is used.
Please order from HENSEL:
Flashtube for EXPERT / INTEGRA PRO series,
user replaceable single coated, Code No. 9450401.
HENSEL Studiotechnik
39