Accessories; Mains Connection - Hensel EXPERT PRO 250 Bedienungsanleitung

Reflector lever
18:
Clamping screw
for umbrellas
HENSEL Studiotechnik
For removing the glass dome, please slightly tilt it again so
that it will easily slip out of the two fixing springs.
Then gently loose the glass dome from the remaining third
spring and remove it from the fixing device.

Accessories

All HENSEL reflectors and HENSEL softboxes of series EHT
(adapter Ø: 10 cm), accessories included, may be attached to
the EXPERT / INTEGRA PRO compact flash; also umbrellas
and Softstar.
Assembly of reflectors and softboxes
For fixing reflectors or softboxes to the compact flash unit,
please first of all open the holding clamps. For doing this,
please tension the reflector lever laterally as far as it will go
against the spring tension. While doing this, the holding
clamps will open. Now even and precisely attach the
accessory part to the unit. Please do not tilt. By releasing the
lever, the holding clamps will completely enclose the
accessory part.
For loosening the accessory, please hold tight the accessory
part (Attention - it could be hot!) and tension the lever again as
described above.
In any case please make sure not to damage either the
flashtube or the modeling lamp (danger!).
Assembly of umbrellas and Softstar
An umbrella holder is integrated in the tilting head that allows
for the connection of various umbrellas by using a strong
gripping spring mechanism. The umbrella is inserted into the
hole above the wing nut 20 and fastened by tightening the
clamping screw 18.

Mains connection

Attention:
Before connecting the compact flash unit to the mains outlet,
make sure, the mains voltage matches the information given on
the type label of the compact flash. The type label can be found
on the bottom of the appliance.
All EXPERT PRO
230V/ 50-60 Hz operation.
The INTEGRA PRO series comes with
technology, i.e. the compact flash adjusts itself for different
main voltages.
Manual EXPERT / INTEGRA PRO Compact
compac flash units are only
multivoltage
for
31