Overview Of Controls - Hensel EXPERT PRO 250 Bedienungsanleitung

Manual EXPERT / INTEGRA PRO Compact
28
6

Overview of Controls

Compact Flash Unit - Controls Front Panel -
1 ON:
2 RC*:
3 AUDIO: Acoustical Ready signal and ON Indicator
4 FC:
5 SLAVE: Slave Switch and ON Indicator
6 TEST:
7 Sync socket
8 Slave
9 Fuse 2A (EXPERT) and 4A (INTEGRA), resp.
10 230V∼/50-60 Hz and 115V∼/60 Hz:
Mains connector
11 FULL : Modeling lamp operation mode and ON Indicator
12 PROP: Modeling lamp operation mode and ON Indicator
13 Flash Power control switch
14 LED Display
Tilting Head - Components -
15 Cable fixation
16 Pre-friction*
17 Shifting of the Tilting Head to balance heavy loads*
18 Clamping screw to hold umbrellas
19 Locking screw for attaching the unit to a stand
20 Wing nut for adjusting the angle of inclination
Radio Transmitter - Controls -
21a Flash Power Down and Modeling light options*
21b Flash Power Up button*
22 Channel selector for 4 channels (DIP switch)
23 Test button for flash triggering
Socket for Sync Cable, ∅ 2.5 mm
24
25 Locking Screw for mounting to the Hot Shoe of the camera
26 Gap for opening the battery compartment
Radio Receiver - Controls -
27 Channel selector for 4 channels (DIP switch)
28 LED green (sync voltage applied)
29 LED red (low battery)
30 Interface socket
31 Gap for opening the battery compartment
* Additional features only available for the respective PLUS version.
Main Switch ON / OFF
Remote Control Switch and ON Indicator
Flash Check Switch and ON Indicator
Manual flash release with Ready Indicator
HENSEL Studiotechnik