General Safety Regulations - Hensel EXPERT PRO 250 Bedienungsanleitung

Proper use
Improper use
HENSEL Studiotechnik
3

General safety regulations

Compact flash systems store electrical energy in capacitors
by applying high voltages. These form a source of danger,
which must be carefully excluded. Besides general rules on
handling electrical
measurements must be observed. Therefore read and comply
the safety hints (also see the paragraph Starting up) within the
user manual before turning the appliance on.
The present compact flash unit is meant for studio use of
professional photographers. Its task is to provide electrical
energy for HENSEL flash lighting.
The appliance may not be used for any other purpose than
that described above, especially not for other electrical
appliances.
Halogen lamps and flashtubes generate high pressure
during operation and can therefore explode. For this
reason it is a must to protect pilot and flashlight with the
supplied correctly installed HENSEL protection glass
dome. The glass dome is available in different versions.
The use of the glass dome changes the colour
temperature.
•
Contact with the capacitor voltage is perilous, and therefore
opening of the case of EXPERT / INTEGRA PRO compact
flash units and repairs must only be made by authorized
customer service.
•
EXPERT / INTEGRA PRO compact flash units are equipped
with a user replaceable flashtube. Exchange of flashtube and
modeling lamp must only be performed with the appliance
turned off, unplugged from the mains and discharged.
•
Compact flashes must only used on supply lines (mains) with
working protective conductor (earth line).
•
Do not route cables across the studio floor if possible, so that
damage is excluded. If routing across the studio floor cannot
be omitted, then it must be ensured that vehicles, ladders, etc.
do not damage cables. Damaged cables and cases must be
immediately replaced by customer service.
Manual EXPERT / INTEGRA PRO Compact
appliances, the following safety
25