Settings; Setting Up A Wireless Connection - avidsen IPC282-MIW Bedienungsanleitung

Motorised 720P WiFi iP caMera
8 Manual start for recording on a computer's
hard disk
9 Display the image full screen (double-click
on image to revert)

2.2 - settings

You can access your camera settings by clicking on
"Réglages système [System settings]" at the top
of the window:
1 2 3 4 5
1 "Système [System]" Section: gives you
access to your camera's basic settings, such
as its n ame and the time settings
2 "Autres [Others]" Section: options for backup
and factory reset, options for restarting and
resetting the camera
3 "Audio & Video" Section: settings for each
video stream, resolution, frame rate
4 "Alerte [Alert]" Section: definition of the zones
and motion detection sensitivity, email
settings for sending alerts via email
5 "Réseau [Network]" Section: all the settings
for wired and wireless network connections.
Here you may define the WiFi network
to which you wish to connect the camera.

2.3 - setting up a Wireless connection

To connect your camera to a WiFi network, go to the
"Réseau [Network]" menu, "WiFi" in your camera's
system settings:
d - CONFigurATiON
1 Click on "Activer [Activate]" to activate
the camera's wireless connection and display
t he WiFi networks detected near the camera
2 IMPORTANT: When you have finished
configuring the device, do not forget to click
on "Sauver [Save]" at the top of the screen
to confirm the entries you have made.
3 The detected networks appear here.
Click on one of them to enter the
corresponding password and get connected.
IMPORTANT: Once your camera is set up to
connect to a wireless network, unplug the network
cable to put these configurations into effect.
Note: The camera's wireless network settings are
also accessible through the app "Avidview" on
Android and iOS:
(See Section F)
1 2 3
en
9