Team ST 27 EC Gebrauchsanleitung Seite 11

Fax +32 2 359 95 50

DUST BAG AND FILTERS

Replacing the dust bag.

Always operate the cleaner with dust bag installed.

Disconnect from electrical outlet before changing dust bag.

Raise dust cover and pull out bag holder.

Remove bag collar from bag holder and pull out dust bag.

Put in new dust bag and close the dust cover.
Motor Filter

Filter should be rinsed clean at least three times a year or when it becomes visibly solid.
Air Filter

Always operate the cleaner with filter installed, otherwise, reduced suction or motor damage
may result.

Disconnect from electrical outlet, before cleaning filter.

Pull filter supporter upward, then remove filter.

Rinse filter in lukewarm water.

Do not use a washing machine for rinsing filter nor use hair dryer for drying it.

Allow the filter to dry completely before replacing it.
TIP
1. When cleaning stairs, we advise you to keep the unit in a vertical orientation.
2. The vacuum cleaner requires no other regular maintenance other than the filter cleaning and bag
replacement tasks as detailed elsewhere.
3. We advise that you ensure the power cord does not become tangled or knotted, as this will
impair the performance of the machine. Always ensure the unit is OFF and unplugged when de-
knotting or untangling the power cord.
4. If you notice a loss of suction power, it is probably due to one or a combination of the following
events:

Blocked filter: clean as described elsewhere

Full or punctured bag: replace as described elsewhere

Blockage in tubes: switch OFF before disassembling and removing the blockage; always
switch OFF before attempting to clean or unblock the unit.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don‟t change the page
numbering. Keep the languages integrity.
Assembly page 11/31
11