Installation And Switching On The Appliance; Before Switching On - Nordmende Rff331Wha+ Bedienungsanleitung

Installation and Switching On The Appliance

• This appliance is connecting to 220-240V 50 Hz. Please check name plate of appli-
ance and be sure voltage range suitable to your mains voltage.
• You can offer help from the service to install and switching on the appliance.
• Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
• A specially grounded plug has been connected to the power cable of your refrigerator.
This plug should be used with a specially grounded socket of 16 ampers. If there is
no such socket in your house, please have it installed by an authorized electrician.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a
well-ventilated position. The refrigerator should be at least 50
cm from radiators, gas or coal stoves and 5 cm far from electrical
stoves.
• Keep the top free for at least 15 cm.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good
performance.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a minimum distance of 2 cm to prevent condensation.
• The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap; the inside
of the appliance with sodium bicarbonate dissolved in luke-
warm water. After drying replace all the accessories.

Before Switching On

• Wait after 3 hours before plugging the appliance in to the main power
to ensure proper performance.
• There can be an odour when you first switch on the appliance. It will
disappear after the appliance starts to cool.
EN - 4 -