Fellowes Starlet 2 120 Anleitung Seite 5

SET UP
A4 A5
1. Ensure the machine is on a stable
surface. Lift the punch handle to its
upright position.
BEFORE YOU BIND
A4
1. Select either A4 or A5 paper size and
test punch scrap sheets. Select the cor-
rect comb diameter to suit the document
(see chart).
STEPS TO BIND
1. Insert sheets fully into the punch slot.
Align the sheets to the edge guide.
TROUBLESHOOTING
Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge
Partial holes
Damaged hole edges
Waste tray leaks
Cannot access document measure feature
2. Lift the punch handle. Check the
waste tray is empty and correctly fitted.
A5
2. Place the binding comb into the
opening mechanism and fully engage
the opening plate by sliding the comb
to the left.
2. When all punched sheets are loaded
onto the comb, close the comb lever.
Possible cause
Edge guide not set
Blockage
Debris is stuck below dies
Sheets not correctly aligned to punch pattern
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst feature'
has activated
Document measure is part of the waste tray
3. Ensure the comb-opening mechanism
is closed.
3. Open the binding comb by turning the
comb lever. Take care not to open the
comb too far.
3. To remove the document, slide the
comb to the right and lift up the docu-
ment.
Solution
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper entry
Take stiff cardboard and slide into the paper entry. Move the cardboard
sideways to release any stray clippings into the waste tray
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of sheets being
punched
Check waste tray is empty and 'burst feature' is closed
Check punch handle is fully raised then remove the waste tray & docu-
ment measure
5