Rear Panel; Specifications - Fender Super-Sonic 22 Bedienungsanleitung

L . POWER— Switches the unit ON-OFF. You can extend the life of
the amplifier tubes by keeping the STANDBY {M} switch down
for the first 60 seconds that the power is ON.
M . STANDBY—In standby, the amplifier outputs are disabled
while power is supplied only to the tube filaments, keeping
them warm. *Tip: Use STANDBY instead of switching the power
off during short breaks to extend the life of the tubes and
avoid the tube warm-up delay upon returning to play.
N . IEC POWER INPUT SOCkET— Connect to a grounded outlet
using the supplied power cord in accordance with the voltage
and frequency specified on the rear panel of your amplifier.
O . FUSE— Protects the amplifier from electrical faults. Only
replace a blown fuse with the type and rating specified on the
rear panel of your amplifier.
TYPE:
PR 904
PART NUMBERS: 2160000x00* (120V, 60Hz)
2160005x00* (220V, 50Hz) ARG
*(Super-Sonic 22 amplifier exterior color code: Black "x"=0, Blonde "x"=4)
POWER REQUIREMENT: 120W
POWER AMP OUTPUT:
22W RMS @ 5% THD, 1kHz sine into 8Ω
INPUT IMPEDANCE: 1MΩ
OUTPUT IMPEDANCE: 8Ω
FUSES 100V-120V UNITS: F 2A L, 250V
220V-240V UNITS: F 1A L, 250V
FOOTSWITCH (INCLUDED):
4-button, (P/N 0078324000) Voicing / Channel / FX on-off / Reverb
SPEAKERS: One 8Ω, 12" Fender Special Design speaker by Eminence® (P/N 0079527000)
DIMENSIONS:
HEIGHT: 17.5 in (44.5 cm)
WIDTH: 24 in (61.0 cm)
DEPTH: 8.5 in (21.6 cm)
WEIGHT: 40 lb (18.1 kg)

Rear Panel

P . MAIN SPEAkER / EXTENSION SPEAkER—
�����������������������
• Keep the internal speaker connected to the INTERNAL SPEAKER
jack for normal operation.
Q . FOOTSWITCH— Connect the included 4-button footswitch to
enable remote selection of: Amp Voicing, Channel, FX Loop
Bypass and Reverb. NOTE: The front panel pushbuttons are dis-
abled when the footswitch is connected.
R . SEND / RETURN— Effects loop jacks. Connect SEND to your
effects input and connect RETURN to the effects output.

Specifications

2160001x00* (110V, 60Hz) TW
2160006x00* (230V, 50Hz) EUR
Product specifications are subject to change without notice.
A speaker MUST be plugged into the INTERNAL SPEAKER
jack when the Super–Sonic amplifier is ON or damage may
occur. Switch the amplifier OFF, or to STANDBY while chang-
ing speaker connections.
2160003x00* (240V, 50Hz) AUS 2160004x00* (230V, 50Hz) UK
2160007x00* (100V, 50Hz) JPN 2160009x00* (220V, 60Hz) ROK
7