Toshiba RBC-WG1-PE Installationsanweisungen Und Funktionsprofil Seite 14

Windows
Number of Units
network input
This input network variable sets the number of units connected on the AI network.
Valid range
The valid range is from 1 to 64.
Default Value
The default value is 0 units. This will be modified after the automatic detection of the
number of units.
The automatic detection of the number of units may be repeated by re-setting this variable
to zero. Setting it to a non-zero value will disable the automatic detection of number of
units.
CONFIGURATION NETWORK VARIABLES
Fault Code Transmission Rate
network input
This UCPT sets the transmission time between fault codes being propagated over the network.
Valid range
The valid range is from 1 sec to 65,000 seconds. Setting this rate to 65,001 disables the fault
code transmission.
Default Value
The default value is 17 seconds.
GB
®
Gateway – Functional Profile
Input Network Variables
nviNumUnits;
SNVT_time_sec nciFaultHrtbeat
14