Auto-Detect Function Procedure; Functional Profile Toshiba Indoor Unit Gateway - Toshiba RBC-WG1-PE Installationsanweisungen Und Funktionsprofil

Windows
To allow the Gateway to auto-detect the number of units connected to it, the following
points must be observed before switching on the Gateway.
1. All indoor units connected to the Gateway must be supplied with 230V AC.
2. The nviNumUnits variable must be set to zero (this variable is set to zero as
factory default).
3. All indoor units are addressed correctly.
If the correct number of units are not detected then reset nviNumUnits to zero and
power on/off the Gateway to re-invoke the auto-detect procedure.
Windows
Overview
This Gateway provides a link between a L
units. It enables settings to be downloaded to the indoor unit and requests made to gather
data from the indoor unit. It is based on Gateway Object type No. 23064.
Example Usage
The indoor unit Gateway is designed to interface with an interactive intelligence system to
enable the indoor units to be controlled and data and settings obtained from them.
GB
®
Gateway – Auto-Detect Function
Procedure
®
Gateway – Functional Profile
Toshiba Indoor Unit Gateway
W
ON ORK
Controller Object
Type No. 23064
10
®
s network and up to 64 Toshiba indoor