Sennheiser ew 300 IEM G2 Bedienungsanleitung Seite 52

50
To mount two transmitters into a rack:
Place the two transmitters side by side onto a flat
surface, their bottom sides facing upwards.
Align the connecting plate
bottom sides of the transmitters.
Secure the connecting plate
supplied recessed head screws (M 3x6).
Hook the two rack mount "ears"
of the transmitters.
Secure the rack mount "ears" to the transmitters
using two of the supplied recessed head screws
(M 3x6) respectively.
Slide the transmitters into the 19" rack.
Secure the rack mount "ears" to the rack.
When mounting only one transmitter into a rack, use the
connecting bar instead of the second transmitter.
Hook the two rack mount "ears"
of the transmitter.
Secure the rack mount "ears" to the transmitter using
two of the supplied recessed head screws (M 3x6)
respectively.
Secure the connecting bar
"ears" using two of the supplied recessed head
screws (M 6x10).
If you are not front mounting the antennas, insert the
two covering plugs
connecting bar.
Slide the transmitter into the 19" rack.
Secure the rack mount "ears" to the rack.
To mount the transmitter's antenna connection to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:
Screw the BNC socket
to the connecting bar
washer and nut.
Connect the BNC connector
the rear of the transmitter.
Slide the transmitter into the 19" rack.
Secure the rack mount "ears" to the rack.
Connect the telescopic antenna
socket .
Pull the end cap to extend the telescopic antenna.
over the holes in the
using eight of the
to the front panels
to the front panels
to one of the rack mount
into the antenna holes of the
of the BNC extension cables
using the supplied plain
to the BNC socket
to the BNC
at