Hozelock 2826 Bedienungsanleitung Seite 4

• To avoid the pump clogging - the pump should
not be placed on the bottom of the water
butt, this can be achieved by either suspending
the pump from a rope attached to the handle,
or by placing the pump on 2 bricks (see Fig. 2).
• The pump has a self priming vent to remove
any trapped air. The priming process can take
up to 5 minutes. For faster priming lower the
pump in to the water without the hose
connected, and connect the hose after a few
seconds once the air has escaped.
TO CONNECT TO AN IRRIGATION SYSTEM:
For use with hoses and hose reels (see Fig. 2)
■
add a 2166 hose connector (available
separately) and pass hose out through hole in
lid of tank.
For use with micro irrigation system - Do not
■
use with a pressure regulator (see Fig. 3)
Remove inlet from pressure regulator and
attach directly to the hose outside of the water
butt using a 2166 hose connector and a 2289
accessory adaptor (both available separately).
TO DRAIN WATER:
- (see Fig. 4) add a 2166 hose connector
(available separately) and place the end of hose
in a suitably sized and positioned container.
Overload protection
• The Hozelock Water Butt Pump has a built in
thermal protection switch. The pump stops if
an overload condition occurs. The motor
restarts automatically after it has cooled
down.
To start the pump
• Insert the pump into a 220-240v A/C socket.
Maintenance
In ordinary conditions the Water Butt Pump does
not require any maintenance, however
occasionally it will be necessary to clean the two
filters and the inlet.
Make sure that the pump is disconnected
from the electric power supply before
performing any maintenance.
• To clean the coarse inlet filter, remove
filter cover on base of pump by twisting
clockwise (see Fig 5A). Remove filter
sponge and rinse in clean water. Replace
sponge and re assemble filter cover.
• To clean the fine outlet filter, remove tap
connector on outlet of pump, remove fine
filter from inside the tap connector and
rinse in clean water (see Fig 5B). Replace
fine filter in tap connector and re-assemble.
(NB – This filter is designed to protect your
Hozelock products from damage due to the
use of dirty water. It is essential to use with
micro irrigation, AquaPod, & all Sprinklers.
It is optional with sprayguns , nozzles &
lances).
Pump storage
Store the pump in a dry place and protect from
frost.
Contact Details
Hozelock Limited
Midpoint Park, Birmingham. B76 1AB
Tel : +44 (0) 121 313 1122
Internet : www.hozelock.com
Email : info@hozelock.com