RUSTA 109013960101 Gebrauchsanweisung Seite 7

3. STRIPPING
Warning: Just before steam is produced, a small amount of bubbling hot water will be
emitted from the wallpaper stripper .
Typically it takes 12 minutes before full steam is achieved. During this time the vapour
hood should be placed in a position where the water and steam that is emitted does not
cause any damage.
Caution: Check the state of the plaster before steaming. If the plaster is loose or
sounds hollow it may be damaged further by steaming.
To achieve the fastest paper removal:
1. Gently score the areas to be stripped. (With heavily embossed, vinyl coated or painted
paper this is essential).
2. Either use a proprietary perforator tool or alternatively score the paper with the
edge of a wallpaper scraper in a criss-cross pattern with a spacing of approximately
150mm (6").
3. Hold the steam plate flat against the wall for approximately
10 seconds. (Fig 4)
4. Move the steam plate to the area immediately beside the one
just steamed and use a wallpaper scraper to remove the paper
from the steamed area.
Note: Working in this way allows continuous wallpaper removal.
For some types of paper, or if there is more than one layer of
paper, the time may need to be extended. Always wear suitable
heat resistant gloves and a long sleeved top.
Beware of hot water accumulating in the steam plate as this could
cause burns if spilt. Do not allow steam near or into electrical
outlets or fittings.
5. Operate until the water level reaches the MIN mark on the water tank, then unplug the
water tank and allow it to cool for at least 5 minutes before removing the filler cap.
Never use the steamer for more than 2 hours at one time as this will cause the steamer
to boil dry.
You must always work in a well ventilated area and if you feel unwell due to the heat
immediately switch off and unplug the steamer and take a break from the work until you
feel better.
Fig 4
7