Optional Accessories; Protecting The Environment - DeWalt D28715 Übersetzt Von Den Originalanweisungen

CRADLE MOUNTING
1. Cut two boards approximately 508 x 50.8 x
101.6 mm (20" long x 2" high x 4") wide.
2. Place chop saw at desired work location.
3. Place boards tightly along side, and nail to work
surface (Fig. 9).
Operation Tips for More
Accurate Cuts
• Allow the wheel to do the cutting. Excessive
force will cause the wheel to glaze
reducing cutting efficiency and/or to deflect
causing inaccurate cuts.
• Properly adjust fence angle.
• Make sure material is laying flat across base.
• Properly clamp material to avoid movement and
vibration.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
NOTE: Unit may be converted to a three-wire twist
lock cord set at an authorized service center.
Lubrication
Closed-type, grease-sealed ball bearings are
used throughout. These bearings have sufficient
lubrication packed in them at the factory to last the
life of the chop saw.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often
as dirt is seen collecting in and around
the air vents. Wear eye protection when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
e
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Use only high-strength Type 1 organic bonded
wheels rated 4100 rpm or higher.

Protecting the Environment

Separate collection. Products and
batteries marked with this symbol
must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for
raw materials. Please recycle electrical products
and batteries according to local provisions. Further
information is available at www.2helpU.com.
english
WALT, have
e
29