Herunterladen Diese Seite drucken

Installation; Maintenance - SuperFish Koi Pro Gebrauchsanweisung

Futterautomat

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB - SuperFish Koi Pro Fish Feeder
With this automatic feeder you can automatically feed your fish.
Feeding a smaller quantity of food on a regular basis has a beneficial effect on
the health of the fish and pond. Only suitable for pellets!
Safety
• Read this manual carefully before usage.
• The Fish Feeder is suitable for outdoor use. Prevent the feeder from falling into the water.
• Ensure voltage shown on the label match to the mains supply voltage.
• The Fish Feeder plug may only be connected to an earthed wall socket. Ensure that water cannot
reach the socket (A).
• Take great care using electricity in combination with water, do not operate with wet hands or plug
is wet. Never operate the feeder if there are people in the water.
• Do not use the Fish Feeder in case of water damage. Warranty is no longer valid if the unit has
water damage or due to improper use.
• Unplug or switch off all appliances in the pond before carrying out maintenance.
• In the event of damage to the unit, cord or plug, do not use the unit and return the unit to your
dealer for repair or recycling
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instructions concerning the use of the appliance in a safe way and
understand the hazards involved. Children may not play with the appliance. Cleaning and user
maintenance shall not be done by children without supervision.

Installation

• Place the Fish Feeder in an accessible place above your pond so that it can be easily refilled with
food.
• Fasten the bracket to a wall (e.g. post) (B) or floor (e.g. on a deck) (C) using 4 screws (not
supplied). Make sure the Fish Feeder hangs completely level (D).
• Place the Fish Feeder in the bracket and feed the cable through the cable guide of the bracket (E).
• Mount the controller with a screw on a wall, in a dry and splash-free location (A).
• Fill the container with pellets (max. 7 litres) and place the lid. Attention: When filling an empty
food container, some pellets will fall out of the dispenser, if necessary you can collect them, for
example by keeping the lid under the fish feeder. Close the lid by turning it anticlockwise.
• Make sure the food stays dry in the container. If the food gets moist, it will be caking and the Fish
Feeder will not function properly.
• The Fish Feeder is suitable for pellets with a diameter between 2-9 mm. Place the reducer (insert
ring) at the bottom of the food container when using small pellets (2-4 mm) (F).
• Insert the plug into a grounded socket and test the Fish Feeder by pressing the controller's
"manual" button. A small amount of food will now be dispensed.
• Set the correct time on the controller and program the desired feeding times and amount of
food. (See Programming). Use the feeding table on the packaging or in the back of this manual as
a guideline.

Maintenance

• Clean the inside of the food container regularly with a brush and a dry cloth. Remove any caked
food remains, these can block the rotor, which can lead to damage and/or malfunction of the Fish
Feeder.
4

Werbung

loading