Installation Instructions - ADEO SCREEN MULTIFORMAT Bedienungs- Und Installationsanleitung

ENGLISH – Rolling screen installation and operation manual
WARNING: When installing the screen use plugs and screws suitable for the screen's weight and for the type of wall or ceiling on which the mount brackets are to be fixed, based on the
following criteria
Screen width view area up to cm
Overall weight
1. Fasten the brackets to the wall or ceiling, respecting the distances
indicated in the figure (the third bracket is present only in versions over 3m
long).
2. Mount the screen by hooking the brackets into the dedicated slots.
3. Tighten the lower screw of the bracket until the case is firmly anchored (it
is not necessary to exert any force).
4.To execute "compulsorily
"the procedures described
to point 2 before using the
screen.
7° operation:
Press the 6 button on the
remote control for open all
fabrics of about 10cm
8° operation:
remove all the seafty
accessories applied on the
surface
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: MULTIFORMAT Installation Manual rev1 |24.08.2018
Please verify that you are working with the latest revision of this document before specifying your screen.

07 INSTALLATION INSTRUCTIONS

225 250 275
Kg 34 Kg 40 Kg 47
5° operation:
To connect the motors to power
(M1 and M2)
ATTENTION! After pressing button 6,
verify that the projection fabrics
opened 10cm.
If the projection fabrics do not moved,
do not press any other buttons, but
manually help the lowbar to get out of
the casing (see illustration).
Now the screen is
ready
300 325 350
Kg 55 Kg 58 Kg 60
Page 12