Informations For Energy-Saving Use; Tips - FUST Novamatic EK 69.7-IB Bedienungsanleitung

– Be careful that no cleaning water can get
into the controller housing (danger of
short circuit).
– Be careful that as little cleaning water as
possible goes though the drainage chan-
nel into the collection dish.
– Before being put back in use, the unit
and the seals of the refrigerator and the
freezer compartment must all be com-
pletely dry.

Informations for energy-saving use

As far as possible, use the cooling unit in
I
its as-delivered state. The arrangement
of drawers, shelves and trays ensures the
best possible temperature distribution.
Do not install the unit near radiators, radia-
I
tor pipes or smoke extractors and protect it
as far as possible for direct sunlight.
Make sure the unit doors are kept open
I
for as short a time as possible. The qui-
cker the doors are closed again, the less
cold is lost.
Make sure that the doors are fully and
I
correctly. The door seal must be flush
against the frame of the fridge.
Leave warm or even hot items to cool
I
down outside the unit.
The storage of moisture-releasing food-
I
stuffs leads to increased build-up of ice
on the rear of the fridge and a reduction
in cooling power.

Tips

The following points should be noted
when using the new refrigerator:
A unit which has just been put into use
I
needs approx. 15 hours (with products)
until it has reached its normal operating
temperatures.
If the doors are open for longer than
I
2 minutes then the refrigerator lamp
starts to flash. Make sure after closing
that the doors are fully sealed. The self-
closing hinges assist this.
The cooling time for beverages and other
I
products can take up to 6 hours from
room temperature down to the refrigera-
tor temperature. The warmer they are
when put in, the longer this time will be.
Re-setting the temperature control has no
I
effect on the cooling rate, only on the
temperature reached.
Condensation can form on the glass
I
shelves if products are stored which emit
water vapour.
Be careful that products do not come
I
into contact with the rear wall of the ref-
rigerator so that they do not freeze to it
and that, during defrosting, water does
not get diverted into the refrigerator.
Take the temperature only in containers
I
with liquids; never measure the air tem-
perature.
When filling be careful that:
I
– Oil and fats do not come into contact
with the polymer parts and the door
seals.
– The coldest locations in the refrigera-
tor for any setting of the temperature
controller are at the back wall and
above the lowest shelf. Sensitive pro-
ducts should therefore be put on the
lowest shelf.
– To avoid possible warming of the pro-
ducts, keep them clear of the lamp.
this will also guarantee sufficient ven-
tilation for the lamp.
33