Replace The Ilters; Replace The Activated Carbon Ilter And The Hepa Ilter - Philips AC4012 Benutzerhandbuch

7 Replace the
filters
The ilter replacement light (
ilters have to be replaced.
Note
•
If you remove the front panel for ilter
changing while the puriier is switched on, all
lights on the control panel will be off.
•
Once the front panel is placed back to the
puriier, all lights lash twice. Then, the puriier
is off. Press the button to switch on the
puriier again.
Replace the activated carbon
ilter and the HEPA ilter
Note
•
The activated carbon ilter and the HEPA ilter
are not washable nor vacuum cleanable.
Replace both the activated carbon ilter and
HEPA ilter when the light goes on. This will
last for approximately 2 weeks.
On the last day of the 2 weeks, the puriier
beeps every 30 minutes to inform you that the
ilter needs to be replaced.
Tip
•
When you remove or insert ilters, place the
puriier against a wall for more stability.
Note
•
Insert the ilters in the correct position.
•
Make sure you place the ilters in the order of
HEPA ilter, activated carbon ilter, and inally
the pre-ilter.
•
Make sure that the side with the tag is pointing
towards you.
16 EN
1
) indicates the
2
3
•
•
Switch off the puriier and unplug it.
Place your ingers in the recesses of the
side panels and gently pull the bottom
part of the front panel towards you. Lift
the panel out of the hooks at the top of
the puriier.
2
1
Remove the ilters using the tag on the
ilter. Take the ilters by both sides and
gently deposit them into the house hold
trash bin.
Note
Do not touch the pleated ilter surface, or
smell the ilter as it has collected pollutants
from the air.
Wash your hands after disposing of the used
ilters.